Page 1 of 1

Culver Road, near Falkville, AL

Posted: Sat May 06, 2017 8:12 pm
by freebrickproductions


Signal on the left: 3 pairs of Safetran 12x24 inch lights with WCH 2nd Generation LEDs.
Signal on the right: 2 pairs of Safetran 12x24 inch lights with WCH 2nd Generation LEDs and a General Signals Type 1 electronic bell.

I went to this crossing as I had heard that CSX was crossing the Tennessee River southbound in Decatur, so I wanted to go out and try and get them at a gateless crossing I hadn't recorded yet. I picked this one due to it being a crossing having old L&N gateless signals at it (though the MI lights and bell were replaced in the late 90s, with an LED upgrade around 2013), but I was honestly expecting a General Signals Type 2 here, so the Type 1 was a very nice surprise!

http://www.rxrsignals.com/Alabama/Falkville/Culver/

Re: Culver Road, near Falkville, AL

Posted: Thu May 11, 2017 11:07 am
by NathanFromEngland
Its in Florida now.

Re: Culver Road, near Falkville, AL

Posted: Thu May 11, 2017 12:31 pm
by ZachL
NathanFromEngland wrote:Its in Florida now.
That was just a coincidental catch right there. That engine could very well be up in Ohio tomorrow for all we know.

Re: Culver Road, near Falkville, AL

Posted: Thu May 11, 2017 1:01 pm
by ToledoRailfan
ZachL wrote:
NathanFromEngland wrote:Its in Florida now.
That engine could very well be up in Ohio tomorrow for all we know.
Poor engine.

Re: Culver Road, near Falkville, AL

Posted: Fri Oct 08, 2021 4:33 pm
by freebrickproductions
Thankfully no changes here as of 8-29-21:


http://www.rxrsignals.com/Alabama/A-F/Falkville/Culver/

Re: Culver Road, near Falkville, AL

Posted: Sat Apr 15, 2023 8:00 pm
by freebrickproductions
Still no changes here as of 3-24-23, thankfully!

Re: Culver Road, near Falkville, AL

Posted: Fri May 31, 2024 11:48 am
by freebrickproductions
Still the same as of 5-15-24: