Page 1 of 1

Henry Ford crossing signal info wanted

Posted: Wed Nov 11, 2026 9:21 pm
by gageplayz10
Hello, this is my first post on here, I usually post on the Siren Board. I went to the Henry Ford earlier this year, and wanted to check out the Wig-Wag. Well, it is no longer there and is replaced by two "new" (vintage restored) gated signals with wishbone gates. There are also other signals (A diamond shaped crossbuck with a bell, and even a Griswold Rotating Banner). Could somebody identify the bells used, the signal origins, and perhaps the manufacturers too? I'll put pics of what I have. Now, I don't know the street names (live miles away in Ohio), so I'll give them my own.
Image
First is this one at the entrance of the Village. It replaced a Wig-Wag (got confused when I first saw it for myself, thinking I was in the wong spot). A black-and-white (then common, now very rare) Wishbone Gate is present. Now, i'm not good with models or specifics of crossing signal components, but I think this is not a genuine vintage peice, but, a modern signal masqeurading as a vintage one. Probably done as a safety upgrade while maintaining the vintage vibe of the village.
Image
This is the full setup. 4 signals, with 2 as standalone gates. Notice the searchlight (I think that's what y'all call them) signal in the back. The crossbucks are reflective (using cats eyes).
I do have more signal shots, but they are in videos, so i'llscreenshot those. Those will be in a follow-up post. All help appreciated.





From, Gage

Re: Henry Ford crossing signal info wanted

Posted: Mon Nov 16, 2026 12:40 am
by freebrickproductions
The gate mechanisms are from WRRS and appear to specifically be WRRS Type 3564 gate mechs. Hard to tell what the 8 inch lights are from your photos, but at least some appear to be WRRS or Harmon 8 inch lights, and some others might be Federal Signal or WCH? There should be logos on the sides or backs of the heads. The bells both appear to be WCH mechanical bells, most likely 2nd Generation ones.